Sub-Zero · Denver, CO
Ice Maker Repair
Clear-ice modules, fill valves and scale on built-in and undercounter Sub-Zero ice makers.
$89 to read the cabinet, then off the bill when you approve the work · out 8:00 am – 8:00 pm, seven days · what the repair itself lands at
How owners describe it
- An empty bin on a machine that is still switched on
- Cubes arriving hollow, undersized or cloudy
- Water freezing on the freezer floor instead of in the mould
- Scale crusted around the mould and the fill tube
What happens on the visit
- 01 You describe the symptom on the phone. On most Sub-Zero faults that already narrows it to a circuit, and you hear what it probably is before anyone drives out.
- 02 On site the cabinet is metered rather than guessed at — sensor readings, defrost circuit, fan draw, pressures where the sealed system is implicated. Panel-ready units come out on sliders and go back the way they were found.
- 03 You get the fault, the part and the price before anything is opened up — the figure for your cabinet, not the band it sits in. The ranges below are what that figure has landed between on this kind of work.
- 04 After the repair the pull-down is watched down to the setpoint, and the readings taken on the day get talked through with you.
What it costs
What ice maker repair costs in Denver
$89 buys a full diagnosis rather than a look, and it is deducted from the price of the repair the moment you give the go-ahead.
Each line is a range because the part decides the number, and the part is not known until the cabinet has been metered. What you get is the exact figure for your repair before anything is opened up — agreed on the day, with the $89 already coming off it once you say go. Nothing is started on an estimate.
- Door seal or gasket renewed
- $270–$680
- Fan motor — evaporator or condenser
- $310–$680
- Defrost circuit: heater, terminator, thermistor
- $280–$690
- Ice module, fill valve or supply line
- $280–$790
- Control board
- $430–$940
- Sealed system, compressor included
- $1,480–$3,420
Worth holding those against the alternative: a comparable built-in replacement, before installation and cabinetry work, $11,970–$20,280. That is why a sealed-system repair on a cabinet with years left in it is usually still the sensible end of the comparison — and why we will say plainly when it is not.
Reviews
Recent ice maker calls in Denver
4.9/ 51,111 reviews
Cubes came out hollow and small for a month. Not the module, as another shop insisted, but low water pressure at the inlet valve. He showed me the flow test he used.
Talia R.Baker
Undercounter maker in the basement bar quit filling. Inlet valve was choked with scale off our hard water. New valve and filter, though the first appointment slipped by a day.
Byron C.Sloan's Lake
Water pooled under the cabinet beside our dining room and I feared for the floor. Drain pump had died and the bin sensor was gummed up. Pump replaced, bin scrubbed, no more puddle.
Hoyt M.Bonnie Brae
Book ice maker repair in Denver
Describe the symptom on the phone and you will usually hear what it probably is before anyone drives out. A $89 service call covers the visit and the full diagnosis in Denver, and comes off the repair once you approve it.
-
Read before quoted
Stored codes first, then air and coil temperatures, then amp draw at start-up, then pressures only if everything in front of them has been ruled out. The readings decide the quote, not the other way round.
-
Refrigeration only
Built-ins, panel-ready columns, undercounter units, ice makers and wine cabinets. No ranges, no dishwashers, no split attention.
-
We will say do not
A sealed-system repair runs $1,480–$3,420. On some cabinets that is money well spent and on some it is not, and you get told which before anything is opened up.
-
Reachable hours
Technicians are out 8:00 am – 8:00 pm, seven days. Someone picks up at any hour, so a failure overnight does not have to wait for an office to open before it is on the list.